Meiko FV 130.2 Specifications download pdf (Page 6)

Page 6

3.5 Main Electrical Supply Connection

WARNING!

Check that the circuit breaker/fused

disconnect is in the OFF position and

that the unit is switched off before

making the electrical utility connections.

IMPORTANT

In some cases, local codes dictate that

electrical supply connections be made only

by a certified professional.

1. Check that the incoming power leads are

of sufficient rating for the appliance’s

current draw. Amperage and minimum

supply wire specifications are shown on

the serial plate and on the electrical

information label on the terminal block

cover plate.

SECTION 3 - INSTALLATION

2. Check that the incoming power leads are

long enough to permit the unit to be

repositioned for servicing.

3. Locate the strain relief for the electrical

supply wiring at the lower rear of the

machine (Figure 3-3). Thread the

incoming supply leads through the strain

relief and to the main electrical supply

terminal block at the front of the machine

(Figure 3-4).

4. Refer to Figure 3-5 and the electrical wiring

diagram. Connect the power supply and

ground leads as indicated.

5. Adjust the strain relief to fasten the wiring

in place. You should leave enough slack

in the wiring to prevent stress on the

terminal connections.

6. Replace the cover above the main

terminal block.

Figure 3-5: Main electrical supply connections

208-230V, 60Hz, 3 Phase

or

460V, 60 Hz, 3 Phase

L1, L2 and L3 “hot” (line)

yel/grn = ground

Figure 3-3: Utility connections

Main

electrical

supply

terminal

block

Lower front

of machine

L2L1

G

N

D

L3

Electrical

supply

strain relief

Lower rear

of machine

Fresh water

connection

Drain

hose

Liquid

detergent and

rinse additive

supply lines (if

so equipped)

Figure 3-4: Routing the

electrical supply

1 2 3 4 5 6 7 8 9 10 11 ... 23 24

Comments to this Manuals

No comments